1. general description the nx5p1100 is an advanced power swit ch and esd-protection device for usb otg applications. it includes under voltage and over voltage lockout, over-current, over-temperature, reverse bias and in-rush current protection circuits. these circuits are designed to isolate a vbus otg voltage source from a vbus interface pin automatically when a fault condition occurs. the device feat ures two power switch terminals, one input (vint) and one output (vbus). it has a cu rrent limit input (ilim) for defining the over-current and in-rush current limit. a voltage detect output (vdet) is used to determine when vint is in the correct voltage r ange. an open-drain fault output (fault ) indicates when a fault condition has occurred, and an enable input (en) controls the state of the switch. when en is set low the device enters a low-power mode, disabling all protection circuits except the undervoltage lockout. th e low-power mode can be entered at anytime unless the over temperature protec tion circuit has been triggered. designed for operation from 3 v to 5.5 v, it is used in power domain isolation applications to protect from out of range operation. the enable input includes integrated logic level translation making the device compatible with lower voltage processors and controllers. 2. features and benefits ? wide supply voltage range from 3 v to 5.5 v ? 30 v tolerant on vbus ? i sw maximum 1 a continuous current ? very low on resistance: 100 m ? (maximum) at a supply voltage of 4.0 v ? low-power mode (ground current 20 ? a typical) ? 1.8 v control logic ? soft start turn-on slew rate ? protection circuitry ? over-temperature protection ? over-current protection with low current output mode ? reverse bias current/back drive protection ? overvoltage lockout ? undervoltage lockout ? analog voltage limited vbus monitor path ? esd protection: ? hbm ansi/esda/jedec jds-001 class 2 exceeds 2 kv ? cdm aec standard q100-011 category c6 exceeds 1 kv ? iec61000-4-2 contact discharge exceeds 8 kv for pins vbus, d ? , d+ and id ? specified from ? 40 ? c to +85 ? c nx5p1100 logic controlled hig h-side power switch rev. 1 ? 21 march 2014 product data sheet
nx5p1100 all information provided in this document is subject to legal disclaimers. ? nxp semiconductors n.v. 2014. all rights re served. product data sheet rev. 1 ? 21 march 2014 2 of 20 nxp semiconductors nx5p1100 logic controlled high-side power switch 3. applications ? usb otg applications 4. ordering information 5. marking 6. functional diagram table 1. ordering information type number package temperature range name description version nx5p1100uk ? 40 ? c to +85 ? c wlcsp12 wafer level chip-s cale package; 12 bumps; 1.36 x 1.66 x 0.51 mm, 0.4 mm pitch (backside coating included) nx5p1100 table 2. marking codes type number marking code nx5p1100uk nx5pb fig 1. logic symbol d d d ( 1 9 , 1 7 9 ' ( 7 , / , 0 ) $ 8 / 7 9 % 8 6 ' ' , '
nx5p1100 all information provided in this document is subject to legal disclaimers. ? nxp semiconductors n.v. 2014. all rights re served. product data sheet rev. 1 ? 21 march 2014 3 of 20 nxp semiconductors nx5p1100 logic controlled high-side power switch 7. pinning information 7.1 pinning 7.2 pin description fig 2. logic diagram (simplified schematic) d d d ' , ' 9 % 8 6 ' 2 9 ( 5 & |